STEP 9 - Final Check & Next Steps
Tyler
Last Update há 7 dias
Micro Trade Test Pre-Check
Before performing a test on your setup to make sure everything is running correctly, check to be sure you have the following completed:
1. Hedge Bot
From left to right, make sure you have...
1. Green checkmark on Hedge Trade Receiver
2. Algo Trading ON (green play button)
3. BLUE hat in upper-right side of chart.
If you DON'T have this, please message our live chat support in the bottom right-hand corner for assistance.
2. Heron Copier Master (Copy Trader Challenges ONLY)
If you DON'T have this, please message our live chat support in the bottom right-hand corner for assistance.
3. Heron Copier Slave (Copy Trader Challenges ONLY)
Make sure you have the green "Copier is connected" on the Heron Slave Copier.
If you DON'T have this, please message our live chat support in the bottom right-hand corner for assistance.
Micro Trade Test
Once you have confirmed the above three are things are done, it's time to place a micro-lot trade on your Titan MT5 chart to make sure the trade copies to your hedge bot account and challenge via the Heron Copier (if this applies to you).
On your Titan MT5 chart, right click and select "One Click Trading".
Make sure that your lot size is "0.01".
Click "BUY".
*NOTE: This will take a trade which will start your challenge.
Check That Trade Is Open
1. Titan MT5
The first place you should see a trade is on your MT5 where you have Titan installed. In this example, we placed a "Buy" trade. You can see the 0.01 lot buy trade at the bottom.
2. Hedge Bot MT5
The next place to check is the Hedge Bot. You should see a trade in the opposite direction (in this example, a "Sell" trade.
*Note: You can ignore the error "Calculated lots is below minimum lotsize. Rounding up to 0.0100". You may exit out of the error pop-up.
3. Copier Trade On Challenge (Heron Copier Users ONLY)
The final place to check is the challenge directly on MatchTrader, TradeLocker, etc. In this example of E8, we simply log in to E8's dashboard and click on the "key" to see the credentials of the challenge.
Click on the "Webtrader link" to open the E8 login for MatchTrader. Log in with the credentials from your challenge on the dashboard.
At the bottom, you should see the same trade open as the one you took on the Titan MT5.
Check That Trade Is Closed
Now that you have checked that things are set up correctly and everything hedges/copies correctly, you can close the trade to be sure everything closes correctly.
1. Titan MT5
Close the trade you originally took on the Titan MT5 by clicking on the "x" next to the trade.
2. Hedge Bot MT5
Check to make sure the trade closed on the hedge account.
3. Copier Trade On Challenge (Heron Copier Users ONLY)
Check to make sure the trade closed on the MatchTrader, Tradelocker, etc. account.
FINAL STEP!
Your final step is to turn on "Algo Trading" on your Titan MT5. It is on when there is a green "play" button and the hat in the upper-right corner of the Titan chart is blue.
Now that everything is set up, your challenge and hedge account will now trade automatically. The next step is to make sure to do your daily checks so that your challenge runs correctly!
Daily Checks (IMPORTANT!)
It's very important that you are checking your account daily to make sure that it is running correctly. Most of the time, this check will only take a couple of minutes. However, at times there may be need for you to take 10 minutes to troubleshoot something to keep your challenge on track.
Please click here to reference the daily checks
Once again, it's vital that you are doing this daily to make sure your challenge is running as it should.